LEAF CATCHALL DIY | LikeWike
DIY Hacks

LEAF CATCHALL DIY

Materials

  • Leaves
  • Air dry clay
  • Roller
  • Craft knife
  • Gloss varnish
  • Paint brush

Steps

1. Break off a small lump of air dry clay and roll out flat and thin. The thinner you can roll your clay the more delicate and lifelike the leaves will look. Be careful not to roll it too thin, though, or your imprint will go right through the clay.

Leaf Catchall Dish-2

2. Lay the leaf over the clay facing upwards. Keep all of the edges within the area of the clay.

Leaf Catchall Dish-3

3. Use your roller to gently press the leaf down into the clay evenly, then peel back the leaf to reveal the pattern and shape it has left.

Leaf Catchall Dish-4 Leaf Catchall Dish-5

4. Cut around the edge of the shape using the craft knife. Try to do this as smoothly as possible and be careful not to rest your hand on the pattern and destroy it.

Leaf Catchall Dish-6Leaf Catchall Dish-7

5. Lift the clay carefully and place into a bowl. This will give the leaf natural and gradual curves at its edges. Leave here to dry overnight. To make sure the clay is 100% hardened, remove the leaf from the inside of the bowl, turn both the leaf and the bowl over and place the clay onto the bottom of the bowl. This means the underneath of the clay leaf can dry fully while keeping its shape.

Leaf Catchall Dish-8Leaf Catchall Dish-9

6. Once the clay is dry, you can paint on two or three light layers of varnish to protect the clay from damage and staining. Leave each layer to fully dry before adding the next.

Previous ArticleNext Article

Leave a Reply

Your email address will not be published. Required fields are marked *